Kile ⇒ How to view KILE Output using Adobe Reader?
-
- Posts: 5
- Joined: Mon May 02, 2011 9:20 am
How to view KILE Output using Adobe Reader?
I am using KILE for past one month. I installed Okular to view the output compiled by KILE. It is good. Now my doubt is, how to view this output using Adobe Reader after compiling a tex file? Please let me know if anybody familiar with this.
Thanks and regards
Ramesh
NEW: TikZ book now 40% off at Amazon.com for a short time.
And: Currently, Packt sells ebooks for $4.99 each if you buy 5 of their over 1000 ebooks. If you choose only a single one, $9.99. How about combining 3 LaTeX books with Python, gnuplot, mathplotlib, Matlab, ChatGPT or other AI books? Epub and PDF. Bundle (3 books, add more for higher discount): https://packt.link/MDH5p
- localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
Re: How to view KILE Output using Adobe Reader?
Thorsten
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
-
- Posts: 5
- Joined: Mon May 02, 2011 9:20 am
Re: How to view KILE Output using Adobe Reader?
I tried as you mentioned but no use.
regrads
ramesh
- localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
Re: How to view KILE Output using Adobe Reader?
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
-
- Posts: 5
- Joined: Mon May 02, 2011 9:20 am
Re: How to view KILE Output using Adobe Reader?
Do you know what settings i should make?
Please tell me if you know, otherwise leave it. Don't waste your time for this. It is working fine with Oklur.
Once again thanks
Ramesh
- localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
How to view KILE Output using Adobe Reader?
You should not use the „Wind0ws method“ to solve problems.jallurameshKUMAR wrote:dude, i tried by re-installing KILE. […]
No, I don't. The problem with AR are the DDE commands to control its behaviour. In opposite to e. g. TeXnicCenter (TXC) on Wind0ws, Kile does not support those DDE commands. I'm not sure if the AR is controllable via command line parameters. And if so, I don't know how this is done.jallurameshKUMAR wrote: Do you know what settings i should make? […]
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Re: How to view KILE Output using Adobe Reader?
Settings->Configure kile->Tools->Build->ViewPDF:Select[Acroread]