General

Don · Post by **Don** » Wed Oct 24, 2007 1:12 am

I have used TeXnic in the past with good success. When I now try to use it after not having done
so for some months, I have troubles. The ``Build'' command takes a long time and, worse, using
the ``build+view'' command leads to error ``cannot execute this command''. Has TeXnic been
changed? Can anyone help?

Learn LaTeX easily with newest books:

The LaTeX Beginner's Guide: 2nd edition and perfect for students writing a thesis

The LaTeX Cookbook: 2nd edition full of practical examples for mathematics, physics, chemistry, and more

LaTeX Graphics with TikZ: the first book about TikZ for perfect drawings in your LaTeX thesis

Post by **localghost** » Wed Oct 24, 2007 4:04 pm

Check the paths to the required binaries in all build profiles. Especially those for the affected viewer. You may start the wizard to rebuild the profiles.

LaTeX.org

General ⇒ When I use the build+view command in TeXnic, I get error.

When I use the build+view command in TeXnic, I get error.

Re: When I use the build+view command in TeXnic, I get error.