General

Don · Post by **Don** » Wed Oct 24, 2007 1:12 am

I have used TeXnic in the past with good success. When I now try to use it after not having done
so for some months, I have troubles. The ``Build'' command takes a long time and, worse, using
the ``build+view'' command leads to error ``cannot execute this command''. Has TeXnic been
changed? Can anyone help?

NEW: TikZ book now 40% off at Amazon.com for a short time.

And: Currently, Packt sells ebooks for $4.99 each if you buy 5 of their over 1000 ebooks. If you choose only a single one, $9.99. How about combining 3 LaTeX books with Python, gnuplot, mathplotlib, Matlab, ChatGPT or other AI books? Epub and PDF. Bundle (3 books, add more for higher discount): https://packt.link/MDH5p

Post by **localghost** » Wed Oct 24, 2007 4:04 pm

Check the paths to the required binaries in all build profiles. Especially those for the affected viewer. You may start the wizard to rebuild the profiles.

LaTeX.org

General ⇒ When I use the build+view command in TeXnic, I get error.

When I use the build+view command in TeXnic, I get error.

Re: When I use the build+view command in TeXnic, I get error.