Greetings,
I am trying to setup the execution modes dialog box in WinEdt to correctly run gind.ist (Or some other ist file, I am open to suggestions.). Evidently, I am not entering the Command line information correctly. An example or two would help. Thank you.
Tom
MakeIndex, Nomenclature, Glossaries and Acronyms ⇒ using gind.ist
NEW: TikZ book now 40% off at Amazon.com for a short time.

- localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
using gind.ist
Supplement the command line arguments for the call of makeindex.
Further information can be found in the manual and the paper.
Best regards and welcome to the board
Thorsten
Code: Select all
makeindex -s gind.ist -g jobname.idx
Best regards and welcome to the board
Thorsten
How to make a "Minimal Example"
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Re: using gind.ist
Thanks, Thorsten, for your response. I am sorry I did not write sooner but my wife and I have been out of town. I read about using ist files before I posted my question. I am still having trouble so I am wondering if there is a conflict with the document class I am using (World Scientific \documentclass{ws-book9x6}). For now I have concentrated my energies on completing the manuscript and I will let WS worry about formatting the index file.
Again, let me express my appreciation for your responses to my question and many other posts. Your instructions are appreciated.
Do you know what happened to CQF?
Tom
Again, let me express my appreciation for your responses to my question and many other posts. Your instructions are appreciated.
Do you know what happened to CQF?
Tom