When I started using Latex a few years ago I setup profiles based on what someone else had done. The two profiles I use are Latex to PDF and Latex to PS to PDF. It seems that some code works with one and not the other but neither profile works with everything. I'm tired of spending time to fix code only to find that the file runs perfectly using a different profile. I currently use TeXnicCenter and hesitate to change because I am so familiar with it.
Is there a profile set up that catches everything?
Thank you.
General ⇒ Too many Output Profiles
Learn LaTeX easily with newest books:
The LaTeX Beginner's Guide: 2nd edition and perfect for students writing a thesis
The LaTeX Cookbook: 2nd edition full of practical examples for mathematics, physics, chemistry, and more
LaTeX Graphics with TikZ: the first book about TikZ for perfect drawings in your LaTeX thesis
-
Stefan Kottwitz
- Site Admin
- Posts: 10360
- Joined: Mon Mar 10, 2008 9:44 pm
Too many Output Profiles
Hi,
welcome to the forum!
TeXnicCenter was great software! Just many years not maintained. If it still runs, fine.
Regarding the two output profiles, you may still need both in the future. In short, because one supports PostScript, and the other supports JPG, PNG, and PDF.
Stefan
welcome to the forum!
TeXnicCenter was great software! Just many years not maintained. If it still runs, fine.
Regarding the two output profiles, you may still need both in the future. In short, because one supports PostScript, and the other supports JPG, PNG, and PDF.
Stefan
LaTeX.org admin