Page Layout ⇒ Increase the space between the end of the header and the text

[Saszalez]

Hello everyone. I have a header where I use a table that I have to put on all the document sheets. When using a table, the header is slightly higher than usual, and the text overlaps the table. I have tried increasing the size of \headsep but without the expected result. How can I do this?

Code: Select all

Code, edit and compile here:

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
\documentclass[english,letterpaper,11pt]{article}
\usepackage{datetime}
\usepackage[T1]{fontenc}
\usepackage{graphicx,algorithmic,algorithm}
\usepackage{fancyhdr}
\usepackage{lastpage}
\usepackage{lipsum}
\usepackage{tabularx}
\usepackage{multirow}
\usepackage{booktabs}
\usepackage{fancyhdr}
\usepackage{lastpage}
%\setlength{\headsep}{-10cm}
\lhead{}
\chead{\begin{tabular}{|c|m{10cm}|c|}
\midrule
\multirow{3}{*}{PROBANDO} & \multicolumn{2}{c|}{\textbf{CÚBICO MEZQUITE PROJECT}} \\
\cmidrule{2-3}
 & \centering Written by ISOBARS team & \thepage \ of \pageref*{LastPage} \\
\cmidrule{2-3}
 & \centering Ref.: 20220801 & August 2022 \\
\midrule
\end{tabular}}
\rhead{}
\renewcommand{\headrulewidth}{0pt}
\pagestyle{fancy}
\begin{document}
%\pagestyle{fancy}
\section{EXECUTIVE SUMMARY}
\lipsum
\end{document}
 
 
הההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההה
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Run LaTeX here

[Bartman]

Using booktabs and vertical lines gives an unappealing result.

Do you really need the page number in the header and footer?

First adjust the height of the header and then decide if you still want to change the space between it and the text.

A suggestion:

Code: Select all

Code, edit and compile here:

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
\documentclass[english,letterpaper,11pt]{article}
%\usepackage{datetime}% obsolete
\usepackage[T1]{fontenc}
\usepackage{lmodern}
\usepackage{babel}
\usepackage{fancyhdr}
\usepackage{lipsum}
\usepackage{tabularx}
\usepackage{showframe}% draws a diagram of the page layout
% A replacement for the lastpage package if your TeX distribution 
% supports the following command.
% Search and read ltnews34 on texdoc.net to get further information.
\AddToHook{shipout/lastpage}{\label{LastPage}}
%\setlength{\headsep}{-10cm}
\setlength{\headheight}{3\baselineskip}
\fancyhead{}
\chead{\begin{tabularx}{\textwidth}{|c|>{\centering}X|c|}
\hline
 & \multicolumn{2}{c|}{\textbf{CÚBICO MEZQUITE PROJECT}} \\
\cline{2-3}
PROBANDO & Written by ISOBARS team & \thepage{} of \pageref{LastPage} \\
\cline{2-3}
 & Ref.: 20220801 & August 2022 \\
\hline
\end{tabularx}}
\renewcommand{\headrulewidth}{0pt}
\pagestyle{fancy}
\begin{document}
\section{EXECUTIVE SUMMARY}
\lipsum
\end{document}
 
 
הההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההה
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Run LaTeX here

[MjK]

Increasing the height of the head this way, also decreases the height of the bottom margin.
So I really recommend to use geometry to change the head height and the margins.

And reading some typography information about construction of typing areas would also be a good idea …

[Saszalez]

Thanks for the answers. Using the geometry package, I thought I could do it quickly, but I have put this, and I don't quite understand the result. I set the sheet size to A4, set the margins to 20mm, and increased the headsep, so there was more space between the bottom of the header and the start of the text. The only thing I get is that the header breaks up off the sheet, not the text goes down. I know I'm doing something wrong, but I can't figure out what. Increase the space between the end of the header and the text.

Code: Select all

Code, edit and compile here:

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
\documentclass[english,letterpaper,11pt]{article}
\usepackage[T1]{fontenc}
\usepackage{graphicx,algorithmic,algorithm}
\usepackage{fancyhdr}
\usepackage{lastpage}
\usepackage{lipsum}
\usepackage{tabularx}
\usepackage{multirow}
\usepackage{booktabs}
\usepackage{fancyhdr}
\usepackage{lastpage}
\usepackage{geometry}
\geometry{a4paper,margin=20mm,headsep=30mm}
\lhead{}
\chead{\begin{tabular}{|c|m{10cm}|c|}
\midrule
\multirow{3}{*}{PROBANDO} & \multicolumn{2}{c|}{\textbf{CÚBICO MEZQUITE PROJECT}} \\
\cmidrule{2-3}
 & \centering Written by ISOBARS team & \thepage \ of \pageref*{LastPage} \\
\cmidrule{2-3}
 & \centering Ref.: 20220801 & August 2022 \\
\midrule
\end{tabular}}
\rhead{}
\renewcommand{\headrulewidth}{0pt}
\pagestyle{fancy}
\begin{document}
%\pagestyle{fancy}
\section{EXECUTIVE SUMMARY}
\lipsum
\end{document}
 
 
הההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההה
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Run LaTeX here

[MjK]

As Bartman already told: headsep is the wrong parameter. I think, you are searching for something like:

Code: Select all

Code, edit and compile here:

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
\documentclass[english,11pt]{article}
\usepackage[T1]{fontenc}
\usepackage{graphicx,algorithmic,algorithm}
\usepackage{fancyhdr}
\usepackage{lastpage}
\usepackage{lipsum}
\usepackage{tabularx}
\usepackage{multirow}
\usepackage{booktabs}
\usepackage{fancyhdr}
\usepackage{lastpage}
\usepackage{geometry}
\geometry{a4paper,margin=20mm,includehead,headheight=20mm}
\lhead{}
\chead{\renewcommand*{\arraystretch}{1.2}
\begin{tabular}{|c|m{10cm}|c|}
\hline
\multirow{3}{*}{PROBANDO} & \multicolumn{2}{c|}{\textbf{CÚBICO MEZQUITE PROJECT}} \\
\cline{2-3}
 & \centering Written by ISOBARS team & \thepage \ of \pageref*{LastPage} \\
\cline{2-3}
 & \centering Ref.: 20220801 & August 2022 \\
\hline
\end{tabular}}
\rhead{}
\renewcommand{\headrulewidth}{0pt}
\pagestyle{fancy}
\begin{document}
\section{EXECUTIVE SUMMARY}
\lipsum
\end{document}
 
 
הההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההה
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Run LaTeX here

As Bartman also told: Tables with booktabs should not use vertical lines. But because it seems you want to have vertical lines, I've uses standard commands for horizontal lines.

[Saszalez]

Thank you very much, it worked perfectly for me.