Graphics, Figures & Tables ⇒ Size Arrangement for Figure

[Kazuki123]

I have a figure for put in my thesis, and when I put into LaTeX the finish PDF was too large (in file size because I create a large figure to fit on full page).

When I decrease the figure and use this, the image was deformed in many points.

Code: Select all

Code, edit and compile here:

1
2
3
4
5
\includegraphics[
  width=0.6\textwidth,
  height=0.9\textheight,
  keepaspectratio=true
]{fig.pdf}
 
 
הההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההההה
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Run LaTeX here

My question is just that, there is a way to catch this small figure created in PDF (which has roughly 3:4 ratio) and put it to occupy a whole page without the image is deformed?

[hugovdberg]

You could specify only width or height, depending on the limiting size, and latex will preserve the aspect ratio for you