Following the examples on the LyX wiki and the LyX mailinglist I tried to uncover a table row-wise in beamer. The examples work just fine, however as soon as I try the same in the beamer conference template that ships with LyX I only get multiple slides of the same table.
Does anyone has a clue what does this cause?
EDIT: The Mailinglist link now refers to the related answer instead only the question.
LyX ⇒ Uncovering table using the beamer conference template
Uncovering table using the beamer conference template
Last edited by gnubbar on Mon Sep 02, 2013 12:08 pm, edited 2 times in total.
NEW: TikZ book now 40% off at Amazon.com for a short time.
-
localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
Uncovering table using the beamer conference template
An answer on the same mailing list, found by search engine. Since I do not use LyX, I can't say anything about its quality.gnubbar wrote:Following the examples on the LyX wiki and the LyX mailinglist I tried to uncover a table row-wise in beamer. […]
Best regards and welcome to the board
Thorsten
How to make a "Minimal Example"
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Re: Uncovering table using the beamer conference template
Thanks for your fast answer, however this is the very approach (and guide) I have used which does not work in the template. I have only linked to the question at the mailing list assuming that it is obvious that I consulted the answers. Now, I have edited the link so that it shows the question and the related answer.