MiKTeX and proTeXt ⇒ Regarding \nomenclature

[pramodrao1984]

Hi friends,
I am using mixtex 2.8 to write my thesis, I have doubt in generating \nomenclature or List of symbols page, I saw replies in forums and in net but I am not able to solve my problem.... can anyone help me please,

thanks in advance
Pramod Rao

[Stefan Kottwitz]

Hi Pramod,

welcome to the board!

For such a purpose I would use the nomencl package or the glossaries package. Just follow the links to get information and documentation. You could compare and decide which one you want to use.

If you encounter problems, you can describe them here, including error messages and as much information as possible. This makes it easier to provide help.

Stefan

[localghost]

Actually the Forum Search should yield a mass of appropriate solutions done either with the glossaries or nomencl package. Perhaps you can enlighten us by a minimal example and clarify what exactly does not work for you.


Best regards and welcome to the board
Thorsten

[pramodrao1984]

Hi Pramod,

welcome to the board!

For such a purpose I would use the nomencl package or the glossaries package. Just follow the links to get information and documentation. You could compare and decide which one you want to use.

If you encounter problems, you can describe them here, including error messages and as much information as possible. This makes it easier to provide help.

Stefan

Firstly thanks Stefan,

here is my file which shows you my .tex file....

1) example.tex ... is with \makeglossary and \printglossary commands along with \userpackage{nomenclature}....
error recieved

[Loading MPS to PDF converter (version 2006.09.02).]
) [1{C:/ProgramData/MiKTeX/2.8/pdftex/config/pdftex.map}]
Overfull \hbox (42.51283pt too wide) in paragraph at lines 28--31
[]\OT1/cmr/m/n/10.95 dkfbvluiabvoiynbdfiaufubdioahnfdoypinabiynajerdyk sd-vbiua
<lbawbsicxzkbfwa vdykuik,nbfv
! Undefined control sequence.
l.46 \printglossary

2) example.tex_edited doesnt have glossary commands...
result: as we can see inspite it doesnt produce nomenclature list .

[pramodrao1984]

Actually the Forum Search should yield a mass of appropriate solutions done either with the glossaries or nomencl package. Perhaps you can enlighten us by a minimal example and clarify what exactly does not work for you.


Best regards and welcome to the board
Thorsten

Thanks Thorsten,

as suggested by you.. I have attached .tex files in my previous post, I have also tried to mention the results and errors I came across.
Kindly help me,
Thanks.