General

inmamy · Post by **inmamy** » Tue Mar 15, 2011 10:13 pm

Hi all,

Is there a way, when I compile my tex file, for the output PDF to go straight to the page I was editing? I'm using Miktex with Winedit 6 in Windows 7. I know Mactex does this automatically but I can't figure out how to do it with Miktex.

I tried googling this question as well as searching within the forums but didn't come up with anything--maybe I wasn't using the right search terms.

Thanks in advance!

Learn LaTeX easily with newest books:

The LaTeX Beginner's Guide: 2nd edition and perfect for students writing a thesis

The LaTeX Cookbook: 2nd edition full of practical examples for mathematics, physics, chemistry, and more

LaTeX Graphics with TikZ: the first book about TikZ for perfect drawings in your LaTeX thesis

west.logan · Post by **west.logan** » Wed Mar 16, 2011 4:17 pm

In MiKTeX, I believe you can hold down the ctrl key and then click to the paragraph you were editing and it will jump to the corresponding point in the PDF file, or vice versa (clicking in the PDF and jumping to the point in the .tex file).

inmamy · Post by **inmamy** » Thu Mar 17, 2011 1:17 am

Thanks for the reply--I tried and it doesn't seem to work. Maybe because I'm using Miktex through Winedit? Anyone else have a suggestion?

west.logan · Post by **west.logan** » Thu Mar 17, 2011 1:49 am

Ah, I see. I thought you just had the vanilla TeXworks setup. I don't know how you would configure it then. I wouldn't guess that Winedit would do it.

LaTeX.org

General ⇒ How to compile to current page?

How to compile to current page?

Re: How to compile to current page?

Re: How to compile to current page?

Re: How to compile to current page?