General ⇒ TeXnicCenter automatically changes double quotes
-
shroomy115
- Posts: 4
- Joined: Thu Jan 13, 2011 4:52 pm
TeXnicCenter automatically changes double quotes
Hi, I noticed when I type a double quotation into TexnicCenter, it automatically changes it to include an extra quote to mark it as either an opening or closing double quote. So " becomes "` or "', depending on if it's opening or closing. Is there any way to disable this autocorrection? Thanks.
Last edited by shroomy115 on Thu Jan 13, 2011 6:23 pm, edited 1 time in total.
NEW: TikZ book now 40% off at Amazon.com for a short time.
-
localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
Re: TeXnicCenter automatically changes double quotes
This behaviour of TeXnicCenter (TXC) is set as default and intended to typeset German quotes in the final output. You can change it by going to the TXC Options and choosing another replacement as shown in the attachment.
Best regards and welcome to the board
Thorsten
Best regards and welcome to the board
Thorsten
- Attachments
-
- The »Options« dialogue in TXC2 alpha 3 for changing the quotation marks replacement (applies also to TXC1 RC1).
- TXC2alpha3-Options-General.png (27.24 KiB) Viewed 4080 times
How to make a "Minimal Example"
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
-
shroomy115
- Posts: 4
- Joined: Thu Jan 13, 2011 4:52 pm
Re: TeXnicCenter automatically changes double quotes
Wow, it's right there. Thanks! I tried searching the forum for the answer before posting and didn't find anything, but after your post I tried again and found some related posts. I must have mistyped something. Anyway, thanks again.