Hi, I am relatively new to Latex. I use TexnicCentre on Miktex 2.7.
I am writing a short report (20 pages) and it has multiple chapters.
There is one chapter which is just a large table. This has page number 16. But the TOC says page 15.
Page 14 is the end of the last chapter and page 15 is blank.
I had not included any \clearpage commands in between.
It's just that the page with the large table is one page off from that reflected by the TOC.
Anyone ever come across something like this before? Any thoughts on why this could be?
Do you need to see my code? It's very basic and I have no other errors.
General ⇒ Page number weirdness
NEW: TikZ book now 40% off at Amazon.com for a short time.

Page number weirdness
Hi,
That would be ideal.akrish wrote:...
Do you need to see my code? It's very basic and I have no other errors.
1,1,2,3,5,8,13,21,34,55,89,144,233,...
Re: Page number weirdness
I actually solved it. I used the \longtable command because I had a feeling that LaTeX was trying to fit the monster table onto one page. Now that it's over two pages, the page number issue is resolved too.
Go figure!
Thanks for your response though
Go figure!
Thanks for your response though

Page number weirdness
Maybe you meant "Go table!"? Just kidding... welcome to the board!akrish wrote:I actually solved it. I used the \longtable command because I had a feeling that LaTeX was trying to fit the monster table onto one page. Now that it's over two pages, the page number issue is resolved too.
Go figure!
Thanks for your response though
1,1,2,3,5,8,13,21,34,55,89,144,233,...