Hello
I'm writing a document where I'm using the package hyperref. A good thing is that it generates a 'content' section in the resulting PDF document that makes the document easily searchable.
Important, see screenshot: http://i.imgur.com/DVWtf.jpg
However, everything is not perfect. In this "Contents" part I would like to add some entries, for example "Cover page" "Table of Contents" etc. I would also prefer if the in-document ToC remains unmodified.
Is this possible, how can it be done?
P.S. Sorry if this is the wrong section of the forum.
Best Regards
Amazon
General ⇒ hyperref | Additional Bookmark Entries to PDF Document
hyperref | Additional Bookmark Entries to PDF Document
- Attachments
-
- The »Contents« section of PDF document in Okular.
- Okular-Contents.jpg (38.2 KiB) Viewed 1599 times
Last edited by localghost on Sun Jul 22, 2012 7:26 pm, edited 1 time in total.
NEW: TikZ book now 40% off at Amazon.com for a short time.

- localghost
- Site Moderator
- Posts: 9202
- Joined: Fri Feb 02, 2007 12:06 pm
hyperref | Additional Bookmark Entries to PDF Document
Perhaps the bookmark package (from the oberdiek bundle) can help you on here. If not, I suggest to read Section 4.1.1 of the hyperref manual.
If the problem persists, prepare a proper minimal example in order to give an adequate problem description. Otherwise the discussion remains academic without any concrete options to help.
Thorsten
If the problem persists, prepare a proper minimal example in order to give an adequate problem description. Otherwise the discussion remains academic without any concrete options to help.
Thorsten
How to make a "Minimal Example"
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10
Board Rules
Avoidable Mistakes
¹ System: TeX Live 2025 (vanilla), TeXworks 0.6.10