I am sure this is just my stupidity or failure to read instructions right, but I would be very grateful of some advice regarding keeping my table on the page.
I have a 2 column paper.
If I set columns to %column width I cannot seem to keep the table on the page pretty much what ever I do.
So I am using %text width. I had expected my %s to need to add up to roughly 100. But it seems with 7 columns I have to set each to 7% and then the table fits exactly the column (but not the text strangely, rather the column).
I wanted it to be a little smaller than this so I set 3 of the columns to just 5% and went straight off the page to the right.
I think I am obviously misunderstanding the meaning of these settings and I would be grateful of some advice.
I had used images for my tables successfully saved to pdf but when I export from pdf acrobat professional to word the images are completely unreadable. Also the ones in the pdf are a little small too.
LyX ⇒ Tables
NEW: TikZ book now 40% off at Amazon.com for a short time.

-
- Site Moderator
- Posts: 542
- Joined: Sat Sep 01, 2012 6:38 am
Re: Tables
As for the table, the reason they don't add up as you expected is that a lot of space in the table is taken up by the dividers of the columns (and the space associated with them).
Re: Tables
OK.
I was surprised it was as much as 50% though
7 columns 7% each 49% of the length
I was surprised it was as much as 50% though
7 columns 7% each 49% of the length