LaTeX forum ⇒ Viewers for PDF, PS, and DVIClose Command for Foxit Reader from within TexnicCenter

Information and discussion about output viewers related to LaTeX (e.g. Adobe Reader, Ghostview, YAP, ...)
Maltetiger
Posts: 1
Joined: Tue May 11, 2021 8:18 pm

Close Command for Foxit Reader from within TexnicCenter

Postby Maltetiger » Tue May 11, 2021 8:46 pm

Hi everyone,
I have been using TexnicCenter 2.0 for a long time now, in combination with MikTex. As to the PDF Viewer, I have now switched to the current version of Foxit Reader (after using a different reader before). Everything works fine with one exception: I cannot find the right command to be written into the TexnicCenter profile settings that would close the current tab of the Foxit Reader, and so every re-compile run of TexnicCenter leads to an error ("Cannot write on **.pdf") if I do not close the Pdf Document manually beforehand. How do I tell Texnic Center to close the current tab of the Foxit Reader?

I have found some discussions on the same problem on the web, but they were rather old and did not help in my case.

Any help would be appreciated.

Thanks,
Malte

Return to “Viewers for PDF, PS, and DVI”

Who is online

Users browsing this forum: No registered users and 2 guests