LaTeX forum ⇒ Page LayoutEDAS treating subfigures within a figure as columns

Information and discussion about page layout specific issues (e.g. header and footer lines, page formats, page numbers).
User avatar
Site Moderator
Posts: 3795
Joined: Thu Nov 01, 2012 4:08 pm

EDAS treating subfigures within a figure as columns

Postby Johannes_B » Sat Sep 09, 2017 8:40 am

Please check if you can replace your current figure with
  1. \begin{figure*}
  2. \centering\includegraphics[width=\textwidth,height=4cm]{example-image}
  3. \caption{Problem Figure}
  4. \label{ProblemFigure}
  5. \end{figure*}

If the error persists, complain to the EDAS team.

If there is no error, your image might be too big (in the example it gets pushed to page 4 because it didn't really fit on page three. Try to split the image. As far as i can tell, this are two different but related data sets.
The smart way: Calm down and take a deep breath, read posts and provided links attentively, try to understand and ask if necessary.


Posts: 6
Joined: Thu Sep 07, 2017 4:52 am

Postby qasimilyas » Mon Sep 11, 2017 2:40 am

Excellent. It worked!
Just in case someone else is looking to solve a similar problem, the set height 4cm did work but it was too small. So I kept increasing it until it didn't work again. Due to the nature of my figures, I set that max height possible (although it was still less than the height of the original figure).

Return to “Page Layout”

Who is online

Users browsing this forum: No registered users and 4 guests